Puch – Crankshafts, bearings, connecting rod

Crankshafts, bearings, connecting rods: for a complete overhaul or repair of your Puch engine the right parts are in stock at JMPB parts. This applies to most models and designs, including for Puch MV, VS, Monza or Maxi with 2, 3 or 4 gears.

Of course, choosing the right crankshaft is important. On the other hand, there is often more possible than many moped riders think. Take for example the difference between an old and new model Crankshaft for Puch Maxi. This difference is only the diameter between the crankshaft hole on the clutch side. The old crankshaft has a diameter of 22mm, and a new type has a diameter of 17mm. It does not matter what engine you have, kickstart or run-up, three or four bearings. The difference is only in the crankshaft and so you can use on any Puch Maxi E50 engine one of these two crankshafts. Make sure that you buy the correct bearings and seals.

With all Puch Maxi crankshafts are the proper seals and bearings shown. Do you nevertheless have a questiont? Let us know, we will give advice on the right parts for your Puch. This includes all related items such as bearing sets, connecting rods and the complete revision sets we provide.

Read Less